Specs for new barbs for a Zalman Reserator 1 v2?

[playtime222]

I broke my quick release couplings on a reserator.

I will just replace them with standard barbs. Only trouble is I don't know the threading or the outer diameter.

Does highflow have any plastic barbs that would fit?

Thanks in advance.

 

[Freddy]

Can you measure with a ruler and let us know the following:
- Diameter of the hole (in millimeters) where a fitting goes into.
- Outer Diameter of the barb (or inner diameter of the tubing).

 

[playtime222]

Inner diameter 12mm of female
Outer diameter 13-14mm of male - just misplaced the damned thing so going off memory.

Tapered thread too.

See image:

Zalman Spare Reserator Quick Release Couplings from Tekheads.co.uk

Hope that's enough for you to work with.

 

[Freddy]

Most probably it is using the default G1/4" thread size.
I don't think the inner diameter of the tubing is 13mm or larger, most likely 8mm or 10mm.
In that case you can order this fitting:
https://www.highflow.nl/watercoolin...-10mm-od/10mm-3-8-high-flow-fitting-g1-4.html

 

[playtime222]

Found it - at the end it's OD is 13mm outside the thread Without the thread the OD is still 11mm.

Ordered something from your store now