• Vragen? Wacht niet langer op de antwoorden! Login of Registreer en plaats jouw vraag! Wij zullen je vragen z.s.m. beantwoorden.

Reageer op onderwerp

5th April Update - Rear chamber




Thank you very much.




Yup you got it, you can place the insert onto the iron and slowly push them exactly where you want them. Be sure to have something on hand when you pull the iron away as they have a habit of coming back out before they set.






Thanks, glad I could share the method!




With the 2 x 7870 and i7 its pretty powerful! Thanks again!


!!UPDATES!!


Sponsors:



Back again. Sorry for the lack of eye-candy; got to get the boring bits done to make the eye-candy better later ;D!


We start with a little drawing:



This is one of the two sections that will make up the back chamber. To hide some cables and enclose the fan controller. Remember there will be a side panel still so some of the boring white will be covered. Tools 45', 1.5mm & 3mm:



Finished:



With both pieces fixed together:



The chamber installed into the back of the case, first use is to hide these molex and other junk in the top. We have actually had to ditch the custom res. We plan to make one in a different spot in the case. It was just to tight to run 4 tubes from the small reservoir AND 4 tubes to each pump. There is also talk of a GPU upgrade and perhaps introducing a rad box to compensate for the new gained power... but we will see!



A helping hand to show you the fan controller in place:



(The controller itself wont actually be seen, more fabrication to come)


Some more photos of the chamber installed:



And a final shot; there is some crazy stuff hiding away in that top chamber!!!



See you all soon!


Terug
Bovenaan