Hello all.
I hope I post this in the right forum as I find it difficult to navigate in here.
Anyway, I have the MCP35x Reservoir from Switech and use the top as inlet for my flow. I have a tube (actually a bitspower thing) running inside the reservoir, Down towards the bottom, and below the top Water level. I can not use this port as a fill port as a result.
I would like to have an extra hole in the top to use as fillport.
I have thouht about drilling a hole and make some threadding for a plug, but I Wold rather if I could use an existing top instead.
I have looked at a top from Alphacool
Alphacool Coolplex bottom piece PM3xG1/4 50mm (Code: A29696) (OD 50mm ID 40mm)
Anyone know the exact thread size of the Swiftech reservoir (I have written to Swiftech, but not heard back yet).
And also thread size of Alphacol?
I hope I post this in the right forum as I find it difficult to navigate in here.
Anyway, I have the MCP35x Reservoir from Switech and use the top as inlet for my flow. I have a tube (actually a bitspower thing) running inside the reservoir, Down towards the bottom, and below the top Water level. I can not use this port as a fill port as a result.
I would like to have an extra hole in the top to use as fillport.
I have thouht about drilling a hole and make some threadding for a plug, but I Wold rather if I could use an existing top instead.
I have looked at a top from Alphacool
Alphacool Coolplex bottom piece PM3xG1/4 50mm (Code: A29696) (OD 50mm ID 40mm)
Anyone know the exact thread size of the Swiftech reservoir (I have written to Swiftech, but not heard back yet).
And also thread size of Alphacol?
Bijlagen
Laatst bewerkt: