Het bekijken van dit forum als gast is beperkt
  • Vragen? Wacht niet langer op de antwoorden! Login of Registreer en plaats jouw vraag! Wij zullen je vragen z.s.m. beantwoorden.

Reageer op onderwerp


A bit of cable management. I won't be needing these cables for a while and wanted them out of the way. I also tried to resleeve them. But I couldn't remove the cables from the 24-pin ATX and the PCI-X connectors. All I managed to do was to break my Sunbeam tool. I'm ignoring it for now, but I will have to deal with it eventually.



The front radiator is in place, complete with red led shrouds and fans. One of the fittings on the radiator is a quick coupling. The fans will be controlled by the pump.



Here it is with the front in place. The colors of the fans are a bit dubious. But they are really good and quiet, so here function was given priority. The picture doesn't really do it justice though. With the fans running and less light it looks ok. I may invest in a new camera once I reach the end of the project so I can take some better pictures.



There will be one reservoir per loop. Each reservoir have four holes. The top ones will go to the fill ports. The bottom ones have plugs which can hold leds (which will be red). The back fittings are quick couplings. And the side fittings will go to the pumps.



Two red cold cathode lights on the bottom of the case.



And two identical inside the case.



The lights come with on off buttons, which I placed on the back. One for the bottom lights and the other for the internal lights.



Here are the cables for the lights. Took a while to sleeve them. I haven't tested the lights yet. So I don't know how they will look.


More below...


Terug
Bovenaan